Zephyr Arc ALU-E43 Notice D'utilisation page 13

All manuals and user guides at all-guides.com
REMOTE CONTROL
SYNCHRONIZATION:
To synchronize the remote control with the range hood for the fi rst time, proceed as fol-
lows:
1. With the range hood off, press and hold the "Power" and "Delay Off" buttons on theremote
for 4 seconds (Fig. 1a) until the "Delay Off" indicator on the hood illuminates (Fig.1b).
2. Press the "Delay Off" button on the hood within 4 seconds to confi rm the link (Fig. 2).If
successful, the "Delay Off" indicator will blink 3 times. The range hood is now syncrhonized
with the remote control. If you experience anyproblems, repeat the procedure.
FCC Caution: To assure continued compliance, any changes or modifi cations not expressly approved
by the party responsible for compliance could void the user's authority to operate this equipment. (Ex-
ample - use only shielded interface cables when connecting to computer or peripheral device. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This
device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
GENERAL INFORMATION:
- Remove any protective fi lm from the remote surface prior to using it.
- The remote control has a range of approximately 10-15 feet.
- The remote control is equipped with a magnetic base and may be attached to ferrous
surface for easy storage.
- The remote top is made of a plastic material and is prone to scratches.
Use care when handling and cleaning the remote; we suggest using a microfi ber cloth to
clean it.
- The remote control will enter a sleep mode after 20 seconds of inactivity to conserve bat-
tery life. Press any button for one second to wake the remote.
BATTERY REPLACEMENT:
The batteries will last approximately 8 months, depending on usage.
1. Remove rubber cover from bottom (Fig.3).
2.Using an object such as a screwdriver or pen, gently place it in the center opening in the
bottom of the remote and push inwards to dislodge the top touch panel from the remote
body. (Fig. 4)
3. Press on the metal spring located in the battery tray to dislodge battery. Replace both
batteries with type 3V CR2450 (Fig.5). Re-assemble by following instructions in reverse.
3 4 5
- 13 -