Thermador Professional Serie Instructions D'installation page 20

en-us Installation
Access the hood's wiring. Route the 30 ft. extension
2.
harness through the strain relief to the square mounting
clip until it clicks.
Route the 30 ft. extension harness through the cutout
3.
and connect the harness to the back of the remote
control bracket.
Press the bracket inside the cutout. Drill a ¼" (6 mm)
4.
tap hole through the bracket holes into the wall. Mount
the bracket to the wall using the four (4) screws
provided.
20
Hook up the wire harness connector inside the bracket
5.
to the terminal on the back side of the remote control.
Use either terminal.
Snap the remote control into the bracket.
6.
5.9 Installing a duct cover (optional)
On some models, an optional duct cover may be used to
fill the space between the hood and ceiling in wall mount
installations. Accessory 6" or 20" – 54" telescoping duct
covers are available for purchase separately.
Attach the duct cover(s) to the hood using sheet metal
1.
screws as shown. The number of screws depends on
the hood size.
From inside of hood, insert ⅝" (16 mm) screws supplied
2.
through the holes indicated on each side and along the
front, into bottom of the cover.