Invacare Sonata Manuel D'utilisation page 10

Invacare® Sonata
(1) High position
Make sure that the bed ends are on the same level. It is
possible to level the bed end in the high position (1) or the
low position (2).
Bed end with integrated legs without bayonet system
Insert the integrated brackets A of the bed end into the side
tube of the mattress platform and tighten the screws firmly
with a 5 mm Allen Key. Do this one end at a time.
Bed ends in combination with separate legs
1.
For Sabrine, Camila bed ends, insert the brackets for the
bed ends into the side tube of the mattress platform.
Tighten the screws firmly with a 5 mm Allen Key.
10
(2) Low position
2.
For the Vibeke bed end, insert the separate brackets for
the bed ends into the side tube of the mattress platform
and tighten the screws firmly with a 5 mm Allen Key.
Lower the bed end board in the U-bracket fitting and
press down firmly to ensure that bed end is fully seated
at bottom of U-bracket fitting.
3.
For Nadine bed ends, insert the integrated brackets A of
the bed end into the side tube of the mattress platform
and tighten the screws firmly with a 5 mm Allen Key.
Lower the bed end board in the U-bracket fitting B and
press down firmly to ensure that bed end is fully seated
at bottom of U-bracket fitting.
Separate legs mounted on mattress support
For bed ends without integrated legs, separate legs need to
be mounted to the cross tubes of the mattress support.
Separate legs are available as fixed and adjustable height
versions, with and without castors.
1574228-E