Toro Titan X4850 Manuel De L'utilisateur page 14

Fuel Gauge
The fuel gauge displays the amount of fuel in the tank
(Figure 7).
Figure 7
1. Fuel gauge
Throttle Control
The throttle controls the engine speed, and it has a
continuous-variable setting from the S
position (Figure 6).
Choke Control
Use the choke control to start a cold engine
Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine
is running. Use these times for scheduling regular
maintenance (Figure 6).
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction
Neutral-Lock Position
Move the motion-control levers outward from the
center to the N -
EUTRAL LOCK
the machine (Figure 32). Always position the
motion-control levers into the N
when you stop the machine or leave it unattended.
All manuals and user guides at all-guidesbox.com
g238298
2. Fuel-tank cap
to F
LOW AST
(Figure 6).
(Figure 5).
position when exiting
- position
EUTRAL LOCK
Parking-Brake Lever
The parking-brake lever is located on the left side of
the console (Figure 5). The brake lever engages a
parking brake on the drive wheels.
To engage the parking brake, pull up the lever until it
latches into the detent slot.
To disengage the parking brake, pull the lever out of
the detent slot and toward you, then push it down.
Foot Pedal Deck-Lift System
The foot pedal deck-lift system allows you to lower
and raise the deck from the seated position. You
can use the foot pedal to lift the deck briefly to avoid
obstacles (Figure 5).
Key Switch
The key switch, used to start and shut off the engine,
has 3 positions: O
FF
Refer to Starting the Engine (page
Blade-Control Switch (Power
Takeoff)
The blade-control switch, represented by a
power-takeoff (PTO) symbol, engages and
disengages power to the mower blades
Height-of-Cut Pin
The height-of-cut pin works with the foot pedal to lock
the deck in a specific cutting height. Adjust the height
of cut only when the machine is not moving
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
12
, R , and S (Figure
UN TART
25).
(Figure
(Figure
6).
6).
5).