Precautions - Sony VPL-FW300L Manuel D'installation

Precautions

On safety
• Check that the operating voltage of your unit is
identical with the voltage of your local power supply.
If voltage adaptation is required, consult with
qualified Sony personnel.
• Should any liquid or solid object fall into the cabinet,
unplug the unit and have it checked by qualified Sony
personnel before operating it further.
• Unplug the unit from the wall outlet if it is not to be
used for several days.
• To disconnect the cord, pull it out by the plug. Never
pull the cord itself.
• The wall outlet should be near the unit and easily
accessible.
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
• Do not look into the lens while the lamp is on.
• Do not place your hand or objects near the ventilation
holes – the air coming out is hot.
• Avoid using an extension cord with a low voltage
limited since it may cause the short-circuit and
physical incidents.
• Do not catch your finger between the unit and surface
of the floor when moving the projector installed on the
floor.
• Be careful not to catch your finger in the cooling fan.
• Do not carry the projector with the cabinet on and with
its cover open.
• Be sure to use two peoples to grasp both sides of the
unit when carrying the unit.
On installation
• When the projector is mounted on the ceiling, the
Sony PSS-630 Projector Suspension Support must be
used for installation.
• Be sure to install the supplied dust cover when
mounting the projector on the ceiling.
• Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies)
that may block the ventilation holes.
Leave space of more than 30 cm (11
between the wall and the projector. Be aware that
room heat rises to the ceiling; check that the
temperature near the installation location is not
excessive.
• Install the projector on the floor or ceiling. Any other
installation causes a malfunction such as color
irregularity or shortening lamp life.
• Do not install the unit in a location near heat sources
such as radiators or air ducts, or in a place subject to
14
Precautions
direct sunlight, excessive dust or humidity,
mechanical vibration or shock.
• To avoid moisture condensation, do not install the unit
in a location where the temperature may rise rapidly.
• Be sure to secure the cabinet cover firmly when
installing to the ceiling firmly.
Warning
For customers who purchase this unit
If customers perform the installation described in this
manual, an accident may occur, causing serious injury.
Never install it by yourself. For installation, be sure to
consult with qualified Sony personnel.
For dealers
Please read this Installation Manual thoroughly for safe
installation.
On illumination
• To obtain the best picture, the front of the screen
should not be exposed to direct lighting or sunlight.
• Ceiling-mounted spot lighting is recommended. Use a
cover over fluorescent lamps to avoid lowering the
contrast ratio.
• Cover any windows that face the screen with opaque
draperies.
• It is desirable to install the projector in a room where
floor and walls are not of light-reflecting material. If
the floor and walls are of reflecting material, it is
recommended that the carpet and wall paper be
changed to a dark color.
On preventing internal heat build-up
• After you turn off the power with the @ / 1 key on the
control panel or on the Remote Commander, do not
disconnect the unit from the wall outlet while the
cooling fan is still running.
• Do not disconnect the AC power cord from the wall
outlet while the fan is still running.
Caution
The projector is equipped with ventilation holes (intake
and exhaust). Do not block or place anything near these
holes, or internal heat build-up may occur, causing
picture degradation or damage to the projector.
On cleaning
7
/ inches)
8
Before cleaning
Be sure to disconnect the AC power cord from the AC
outlet.
On replacing the air filters
When the air filter replacement message appears,
replace both air filters with new ones.
For the air filter replacement, refer to "Replacing the
Air Filters" in the supplied Operating Instructions.