Publicité
Les langues disponibles
Les langues disponibles
For connecting, use an approved cable with the correct cable
diameters appropriate for the connection. The cable casing should
be made of rubber (preferably of the H05V2V2 or H07V2V2 type).
Before connecting the appliance, make sure the voltage indicated
on the rating plate conforms to the voltage in your power mains.
The connection should be adjusted to the current and fuses.
The appliance should not be connected to the mains via a
multi-plug adapter or extension cable, as the safe use of the
equipment cannot be guaranteed.
After installation, the parts carrying electrical current and insulated
parts shall be protected against contact.
WARNING!
Failure to use screws or fasteners for installation as described
in the installation instructions may result in electric shock.
Gas connection
Gas connection 1/2" ISO 228 / ISO 7-1 / EN 10226-1 (1/2" ISO
228 / 1/2" ISO 228 FR only).
The gas connection must comply with national and local
regulations. See appliance label for technical gas data.
This appliance is not connected to a combustion products
evacuation device. It shall be installed and connected in
accordance with current installation regulations. Particular attention
shall be given to the relevant requirements regarding ventilation.
We recommend that the gas hob be connected by means of a
fixed pipe. Connection using a specially designed safety hose is
also permitted.
The pipe behind the oven must be made entirely out of metal.
A safety hose may not be bent and must not come into contact
with moving parts of kitchen units.
The gas supply valve must always be placed in an easily
accessible position.
Installation
35
Publicité
