Seca 655 Mode D'emploi page 94

Knurled wheel
5.4 Connecting a barcode scanner (optional)
94 • seca 655/654
4. Tighten the knurled wheels in the direction of the arrow.
The foot screws are secured against being adjusted.
5. Calibrate the ultrasonic measuring rod ➔
measurement, page 109.
A barcode scanner can be connected to the USB interface of the weighing
platform.
The barcode scanner is required for the following functions:
• Configuration: Define network data in the
and transfer them to the device using the QR code: ➔
network functions, page 115
• Operation: Record patient and user IDs for transmitting measuring re-
sults to an EMR System: ➔
page 105
WARNING!
Patient hazard
► Route the connecting cable so that patients cannot become caught
or strangle themselves in it.
► Route the connecting cable so that patients and users cannot
stumble.
NOTE
• Observe the maximum permitted current consumption of the
barcode scanner ➔
• Use only barcode scanners recommended by seca ➔
accessories and spare parts, page
To connect a barcode scanner, proceed as follows:
1. Make sure that the device is disconnected from the power supply.
2. Plug the USB connector of the barcode scanner into the USB socket of
the multifunctional display.
3. Hang the barcode scanner in a suitable holder (e.g. scanner holder
➔
seca 463 Optional accessories and spare parts, page
Calibrating ultrasonic height
seca connect 103
Completing the measurement procedure,
General technical data, page
137.
software
Setting up
135.
Optional
137.