Beko CN 148220 Mode D'emploi page 9

3 Installation
B
Please remember that the
manufacturer shall not be held liable if
the information given in the instruction
manual is not observed.
Points to be considered
when re-transporting your
refrigerator
1.Your refrigerator must be emptied and
cleaned prior to any transportation.
2.Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
3.Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
Please do not forget...
Every recycled material is an
indispensable source for the nature
and for our national resources.
If you wish to contribute to recycling
the packaging materials, you can
get further information from the
environmental bodies or local
authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1.Is the interior of the refrigerator dry and
can the air circulate freely in the rear
of it?
2.Please install the 2 plastic wedges
as illustrated in the figure. Plastic
wedges will provide the required
distance between your refrigerator
and the wall in order to allow the air
circulation. (The illustrated figure is
only an example and does not match
exactly with your product.)
All manuals and user guides at all-guides.com
3.Clean the interior of the refrigerator as
4.You will hear a noise as the
5.Front edges of the refrigerator may feel
Electric connection
Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
• The connection must be in compliance
• The power cable plug must be easily
• The specified voltage must be equal to
• Extension cables and multiway plugs
B
8
EN
recommended in the "Maintenance
and cleaning" section.
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
warm. This is normal. These areas
are designed to be warm to avoid
condensation
with national regulations.
accessible after installation.
your mains voltage.
must not be used for connection.
A damaged power cable must be
replaced by a qualified electrician.