Kenwood DPX530BT Mode D'emploi page 32

INSTALLATION / CONNECTION
Installing the unit (in-dash mounting)
Do the required wiring.
( 29)
Dashboard of your car
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2
Align the holes in the unit (on both sides) with the vehicle mounting bracket and
secure the unit with screws (commercially available).
Use only the specified screws. Using wrong screws might damage the unit.
28
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
Part list for installation
(A) Mounting sleeve
(C) Wiring harness
How to remove the unit
Insert the extraction keys deeply into the slots on
each side, then follow the arrows as shown below.
(B) Trim plate
(D) Extraction key