JVC BR-DV600AE Mode D'emploi page 61

AUDIO/VIDEO menu
Items
AUDIO MODE 48K
32K
A.OUT AT OFF
SEARCH ON
AUDIO OUT SEL CH1/CH2
MIX
CH3/CH4
Memo
When it is set to the MIX
mode, noise may be pro-
duced. If this occurs,
please set it to CH1/CH2
or CH3/CH4.
AUDIO OUT ATT
LEVEL NORM
SET UP OFF
(NTSC only) ON
PAGE BACK
Setting
Select the audio sampling frequency for recording:
48K : Records at 48kHz. It records in the 2-channel stereo mode.
No audio dubbing.
32K : Records at 32kHz. It records in the 4-channel mode. To per-
form audio dubbing on CH3 and CH4 later, use this setting.
Memo
This setting is not required for DV signal input.
Use this menu item to enable/disable audio output from the AU-
DIO OUT terminal during a search:
OFF : No output.
ON : Output.
Use this menu item to select the audio channel output from the
AUDIO OUT terminal when playing back tapes recorded in the
32K mode:
CH1/CH2 : Outputs CH1 and CH2 audio.
MIX
CH3/CH4 : Outputs CH3 and CH4 audio.
Memo
This setting can also be selected from the AUDIO OUT SEL. but-
ton on the wireless remote controller.
Use this menu item to select the standard level for audio playback
output:
ATT : Attenuates the standard level to –12db. Use this setting
NORM : Sets the standard level to –20dB. Usually, this is selected.
Memo
This setting can also be selected with the AUDIO OUT LEV. button
on the wireless remote controller.
Use this setting to determine whether to apply the setups to the
analogue video signals (composite, Y/C):
(For recording and playback)
OFF : does not apply the setups.
ON : applies the setups.
Memo
• If dubbing is repeatedly done with the settings of the playback or
recording video signals differing from the setting here, the hue
and brightness of the video may turn out abnormal.
Return to the top MENU.
Contents
: Outputs mixed audio of CH1 and CH3 and mixed au-
dio of CH2 and CH4.
when playing tapes recorded at the standard level of
–12dB. The playback level is decreased by 8db.
E-61