Dell S4048T-ON Guide De Mise En Route page 31

Configure as described in the following topics:
1. Configuring the Management Port IP Address
2. Configuring the Management Route
3. Configuring the Username and Password
Configuring the Management Port IP Address
In order to access the system remotely, assign IP addresses to the
management ports.
1. Enter INTERFACE mode for the Management port.
CONFIGURATION mode
interface ManagementEthernet slot/port
2. Assign an IP address to the interface.
INTERFACE mode
ip address ip-address/mask
3. Enable the interface.
INTERFACE mode
no shutdown
Configuring the Management Route
Define a path from the S4048T–ON to the network from which you are
accessing the S4048T–ON remotely.
Management routes are separate from IP routes and are used to manage the
S4048T–ON through the management port.
• Configure a management route to the network from which you are
accessing the system.
CONFIGURATION mode
management route ip-address/mask gateway
Configuring the Username and Password
To access the system remotely, configure a system username and password.
• To access the system remotely, configure a username and password.
CONFIGURATION mode
29