Publicité
Les langues disponibles
Les langues disponibles
Symptom
"Please Eject" appears on the display.
"Not Support" appears on the display and
track skips.
"Reading" keeps flashing on the display. A longer readout time is required. Do not use too many hierarchical
Noise is generated.
Tracks/folders are not played back in the
order you have intended.
While playing a track, sound is
sometimes interrupted.
"USB-Error," "Remove Device,"
"Power OFF = ON" appears on the display.
"Cannot Play" flashes on the display. /
"No USB" appears on the display. / The
unit cannot detect the USB device.
"No File" appears on the display.
"Not Support" appears and track skips.
"Read Failed" appears on the display.
"BT FRONT/ BT REAR" cannot be
selected.
No Bluetooth device is detected.
Pairing cannot be made.
Echo or noise occurs.
Phone sound quality is poor.
The unit does not response when you
tried to copy the phonebook to the unit.
The sound is interrupted or skipped
during playback of a Bluetooth audio
player.
Remedy/Cause
Insert a disc that contains MP3/WMA tracks.
Skip to the next track encoded in an appropriate format or to the
next non-copy-protected WMA track.
levels and folders. / Turn off the power then on again. / Reattach
the USB device again.
Skip to another file.
The playback order is determined by the file name. Folders with
numbers on the initial of their names are sorted in numerical order.
However, folders with no numbers on the initial of their names are
sorted according to the file system of the USB device.
The tracks have not been properly copied into the USB device. Copy
tracks again into the USB device, and try again.
An over-current occurs. Turn off, then turn on the unit.
Check whether the connected USB device is compatible with this
unit. / Reattach the USB device again.
Check whether the device contains playable files.
Check whether the track is a playable file format.
The connected USB device is not working properly. Connect the
USB device again.
Check the <Source Select> = <Bluetooth Audio> setting.
(page 29)
Search from the Bluetooth device again. / Reset the unit, then
search from the Bluetooth device again.
Make sure you have entered the same PIN code to both the unit and
target device. / Disconnect the Bluetooth device and try pairing again.
Adjust the microphone unit's position.
Reduce the distance between the unit and the Bluetooth mobile
phone. / Move the car to a place where you can get a better signal
reception.
You may have tried to copy the same entries (as stored) to the unit.
Press DISP or BACK to exit.
Reduce the distance between the unit and the Bluetooth audio
player. / Disconnect the device connected for Bluetooth Phone. /
Turn off, then turn on the unit. / Connect the player again, when
the sound is not yet restored.
Continued...
ENGLISH
31
Publicité
