Publicité
AVERTISSEMENTS
WARNING – STARTER MAY START OR STOP UNEXPECTEDLY
The soft starter will respond to control commands from various sources,
and could start or stop unexpectedly. Always disconnect the soft starter
from mains voltage before accessing the starter or load.
WARNING – DISCONNECT MAINS BEFORE ACCESSING STARTER OR
LOAD
The soft starter has built-in protections which can trip the starter in the
event of faults and thus stop the motor. Voltage fluctuations, power cuts and
motor jams may also cause the motor to trip.
The motor could restart after the causes of shutdown are rectified, which
may be dangerous for personnel. Always disconnect the soft starter from
mains voltage before accessing the starter or load.
WARNING
Do not apply mains voltage to the starter until all wiring is complete.
WARNING
Always apply control voltage before (or with) mains voltage.
WARNING
When connecting the soft starter in inside delta configuration, always install
a main contactor or shunt trip circuit breaker.
WARNING
If the start input is closed when control voltage is applied, the starter will
attempt to start.
Check that the start/stop input is open before applying control voltage.
Manuel de l'utilisateur EMX4i (710-17474-00B) |
7
Publicité
