Publicité
Les langues disponibles
Les langues disponibles
EN
38
FM RADIO
Carefully extend the telescopic aerial to its full length.
Auto Scan
1. Rotate the SOURCE knob to select "FM Mode".
2. Long press the
button, and your radio will scan and stop automatically
when it finds a station of sufficient signal strength.
3. After a few seconds, the display will update. The display will show the
station frequency. If the signal is strong enough and the station signal
contains RDS data, then the radio will display the station name.
4. To find other stations, press and hold the button as before.
5. To scan the FM band in the opposite direction (high frequencies to low
frequencies), press the button and hold for 2 seconds.
6. When the waveband end is reached, your radio will recommence tuning
from the opposite waveband end.
Manual Scan
1. Rotate the SOURCE knob on the main unit to select "FM Mode''.
2. Select FM mode as previously decribed, if required.
3. Press / to tune to a station. Each press of the tuning button will
change the frequency up or down by 100 kHz.
4. When the waveband end is reached, the radio will recommence tuning
from the opposite waveband end. If no stations are found, please ensure
the aerial is extended and test the reception by doing another auto scan
in a different location.
Menu
1. Scan Setting
2. In FM mode, press MENU, enter the FM menu setting, then press or
to select [Scan setting], then press ENTER to select the sensitivity
setting:
Publicité
