Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
clockwise in the pump，the cooperation gap between the pump enclosure and the pump core should be
kept in 06~0.08mm，to ensure that the air pump can produce sufficient pressure.
◆ fixation of the fan blades
Install fan blade on motor shaft und use set screw to tighten them firmly
【
】
Trouble analysis
Before you send out the heater for repair please check the following points first, they are not faults：
Problem
Odor, smoke or spark omitted by the first use
Ignite when he first use or when the fuel was used
out, strange sounds, odor, white smoke
Strange sound while igniting or flameout
Fire appears out of the outlet while igniting.
Sparkle
【trouble shooting guide--reason and solution】
A．pump body
B . gap 0.06~0.08mm
C．pump core
D．screw
E．pump blade
It is normal. Because at the beginning there are
air and dust mixed in the burning. Wait for some
time they will disappear.
Air is mixed in the pipe, the phenomenon will
disappear when the air in the pipe was pressed
out.
The metal parts of the heater expand and
contract cause the noises. normal
Fuel and air of last time were left in the oil pipe of
the nozzle, so the air and fuel are not proper
mixed, the burning isn't continuous. Sparkle is
caused by the left carbon powder, is also normal
A．fan blade
B．motor shaft
C．set screw
reason
33
Publicité
Table des Matières
