Inglesina DARWIN INFANT RECLINE Manuel D'instructions page 41

CARE AND MAINTENANCE
It is recommended to remove the lining periodically to provide for its correct
maintenance.
fig. 17 Bring the handle (A) to the most rear position.
fig. 18 Pull the rear belts out of their protection.
Then remove the headrest cover from the frame, taking care to pass the rear straps
through the slots provided.
fig. 19 Ensuring that the headrest is fully raised, remove the seat lining by first
detaching the upper snaps (I1) under the headrest structure and then the lower ones
(I2).
Pull the crotch strap (C) first out of its protection and then out of the slot.
fig. 20 Finally, remove the lining (J) from the frame by releasing the hooks (J1) from
their seats and detaching the elastic band (J2) attached to the reclining seat.
INSTALLING THE SEAT IN THE CAR
fig. 21 When the car seat is used in the car without the base, the seat cannot be
reclined.
Acting on the recline button (I) in fact raises two red barriers (F2) at the side seats (F)
that prevent the car's seat belt from passing through, inhibiting its use.
Verify that on the vehicle seat there are not any items that may hinder the correct
leaning of the Darwin Infant Recline child car seat.
Verify that the backrest is in vertical position and the vehicle seat where the child car
seat has to be installed is NOT EQUIPPED WITH ACTIVE FRONT AIRBAG.
CAUTION: make sure the seat is NOT reclined.
Install the Darwin Infant Recline car seat only FACING IN THE DIRECTION OPPOSITE
TO THE DIRECTION OF TRAVEL.
fig. 22 Pass the lower segment (F1) of the car safety belt through the lateral seats
(F).
fig. 23 Hook the car safety belt properly.
fig. 24 Rotate the handle (A) to the most forward position. Make sure that the two
buttons (A1) completely come out, after having arranged the handle to the proper
position.
fig. 25 Pass the diagonal segment (G1) of the car safety belt through the rear
guides (G).
fig. 26 CAUTION: make sure that the belts are well stretched and not twisted.
Only in this way it is possible to obtain the perfect anchoring of the Darwin
Infant Recline car seat.
When the child car seat is used without the base, it is advisable to check that the
hatched red line on the symbol (K) on the side of the child car seat is more or less
parallel to the ground.
INSTALLING THE CAR SEAT WITH THE DARWIN i-SIZE BASE
Install the Darwin i-Size Base on board of the car referring to the dedicated manual.
fig. 27 Install the Darwin Infant Recline car seat by inserting the 2 tubes (K1) in the
housings (L) in the base until the CLICK indicating attachment is heard on both sides.
fig. 28 The Darwin Infant Recline car seat is attached when the dedicated indicators
(L1) change from red to green.
Check that the car seat is correctly attached by trying to lift it.
fig. 29 The Darwin Infant Recline car seat can be installed on the Darwin i-Size base
even when reclined.
fig. 30 Once the Darwin Infant Recline car seat is attached to the Darwin i-Size
41