Inglesina DARWIN INFANT RECLINE Manuel D'instructions page 42

base, press the two buttons (A1) simultaneously and rotate the handle of the car seat
forwards as far as it turns. Make sure that the two buttons (A1) come out completely,
after arranging the handle in position.
REMOVING THE CAR SEAT FROM THE DARWIN i-SIZE BASE
fig. 31 Pressing the two buttons (A1) simultaneously, rotate the handle of the car
seat to vertical position.
The Darwin Infant Recline car seat can be removed in two ways.
fig. 32 Option 1. - Operating the rear lever (H), simultaneously lift the Darwin
Infant Recline car seat from the Darwin i-Size base, gripping it with the handle.
fig. 33 Option 2. - Pressing the release lever (M) on the base, simultaneously lift the
Darwin Infant Recline car seat from the Darwin i-Size base, gripping it with the handle.
INSTALLING THE CAR SEAT WITH THE DARWIN 360° i-SIZE BASE
Install the Darwin 360° i-Size Base on board of the car referring to the dedicated
manual.
The Darwin 360° i-Size base can rotate to facilitate positioning of the child and
installation of the car seat in the car.
fig. 34 Using the front levers (N) rotate the car seat installation seat (P) to the
desired position.
fig. 35 To install the Darwin Infant Recline car seat, ensure that the release button
(Q) is located at the front of the seat (child's feet), then couple both slots (K2) on the
side latch fittings, to the reference (P1) on the installation seat, then press down until
the clicks are heard.
fig. 36 Correct attachment of the Darwin Infant Recline car seat occurs when both
indicators (P2) on the base installation seat turn from red to green.
Check that the car seat is correctly attached by trying to lift it.
fig. 37 Once the seat is installed, rotate it to the position against the direction of
travel.
fig. 38 Correct positioning of the Darwin Infant Recline car seat with respect to the
direction of travel only occurs when the indicators on the base (P3) turn from red to
green.
fig. 39 In the event that the Darwin Infant Recline car seat is rotated to positions
other than against the direction of travel, the indicators on the base (P3) will remain
red, thus notifying the incorrect position of the car seat in the car and the consequent
prohibition of use.
fig. 40 Once the Darwin Infant Recline car seat is attached to the Darwin 360°
i-Size base and rotating against the driving direction, press the two buttons (A1)
simultaneously and rotate the handle of the car seat forwards as far as it turns. Make
sure that the two buttons (A1) come out completely, after arranging the handle in
position.
fig. 41 When the Darwin Infant Recline seat is installed on the Darwin 360° i-Size
Base, it can be reclined to allow the child a better rest while travelling.
CAUTION: transporting a child in a car is only permitted when all indicators on
the base have turned from red to green.
REMOVING THE CAR SEAT FROM THE DARWIN 360° i-SIZE BASE
fig. 42 Pressing the two buttons (A1) simultaneously, rotate the handle of the car
seat to vertical position.
The Darwin Infant Recline car seat can be removed in two ways.
fig. 43 Option 1. - Operating the rear lever (H), simultaneously lift the Darwin
42