Publicité
Les langues disponibles
Les langues disponibles
3. Depending on its condition, rinse the outside of the filter
under lukewarm running water.
4. Secure the filter again by placing it over the suction opening
and turning it clockwise.
WARNING :
•
Do not wash the inside of the filter.
•
Let the filter dry thoroughly if the inside becomes wet.
•
Do not use a brush to clean the filter.
•
Never use compressed air or a brush to clean filters,
otherwise damage to the filter membrane will occur
which will allow dust to pass through the filter.
Cleaning the Suction Opening Filter (Fig. G)
The suction opening filter needs to be cleaned if the appliance is
operated without the dust filter in place.
1. Keeping the float valve
from the suction opening
2. Rinse the filter under lukewarm running water.
3. Dry the filter before putting it back in place.
4. Clean the float valve
18
Troubleshooting
If your vacuum seems not to operate properly, follow the
instructions below. If this does not resolve the problem, please
contact your repair agent.
Problem
Motor does not run
Suction capacity decreases
out of the way, remove the filter
18
17
.
using a damp cloth.
Solution
Check power cord, plugs and
outlet, or battery contact,
charging condition of battery
Ensure the on/off/tool
control switch is in the ON
position I.
Remove blockages in the
suction nozzle, suction tube,
suction hose, float valve
or filters.
Check for proper installation
of the filters.
Clean or replace the filters.
Empty canister, refer to
Empty Tank under Operation.
Problem
Vacuum stops running
Dust comes out while
vacuuming
If Shut-off Feature Engages
1. Turn off the vacuum immediately.
2. Empty the tank as described above.
3. Clean the suction opening filter as described in Cleaning
the Suction Opening Filter.
4. Remember to put the dust filter in place before
resuming work.
MAINTENANCE
Your D
WALT appliance has been designed to operate over
e
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
appliance care and regular cleaning.
WARNING: To reduce the risk of injury, turn
appliance off and disconnect appliance from power
source before installing and removing accessories,
EnGLIsh
Solution
Thermal overload has been
tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner
from power source.
2. Empty the canister,
if needed.
3. Allow the unit to cool.
4. Plug the power cord into
an appropriate outlet or
battery into battery port
and turn on/off/tool control
switch to the ON positon I
to test. If vacuum will not
restart contact your seller or
check the location of your
nearest authorised D
WALT
e
repair agent in the D
WALT
e
catalogue or contact your
D
WALT office at the address
e
indicated in this manual
Check for proper installation
of the Filter and dust tank.
Ensure filter is not damaged;
replace if necessary.
Ensure filter seals are in place
and are secure.
If furthermore dust comes
out while vacuuming
contact your seller or
check the location of your
nearest authorised D
WALT
e
repair agent in the D
WALT
e
catalogue or contact your
D
WALT office at the address
e
indicated in this manual.
37
Publicité
