Dacor DOP30 940 Serie Mode D'emploi page 45

Care and maintenance - Oven
88 English
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 88-89 DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 88-89
5. Repeat for the right (front and back)
slide mechanism of the rack.
6. Open and close the rack several times
to distribute the lubricant.
7. Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5, and 6.
8. Close the rack, turn the rack right-
side-up, and then install it in the oven.
See Installing the gliding rack on page
43.
NOTE
Do not spray the gliding rack with cooking
spray or other lubricant sprays.
Ladder racks
Ladder Racks can be removed for manual cleaning or to prevent discoloration during a
Self-Cleaning cycle.
Removing the Ladder racks
1. Grasp the Position 2 rack guide, and
then lift the Ladder Rack straight up.
This frees the Ladder Rack from its
two supports on the oven wall.
2. Rotate the Ladder Rack by
approximately 45°.
3. Pull the Rack away from the oven wall
to remove it from the two support
holes in the wall of the oven.
4. Repeat this procedure with the Ladder
Rack on the opposite wall.
English
2023-01-17 오후 3:02:01 2023-01-17 오후 3:02:01
89