Publicité
Les langues disponibles
Les langues disponibles
Using the oven
How to run a self cleaning cycle
1. Make sure the oven door is unlocked and closed
2. Turn the mode and temperature selector knobs to
3. Turn the mode selector knob from Off to the Clean
4. Press <, > to select Self Clean mode. Press OK to start
Clean Mode
5. Set the self cleaning time. 3 hr is the default. Press
Self Clean
6. The oven door is locked and the oven begins to
7. When the Self-Cleaning cycle is complete, turn the
NOTE
• You will not be able to start a self-cleaning cycle if the control lockout feature is
activated or if the oven's temperature is too hot.
• The oven doors lock automatically. The display will show the remaining cleaning time.
You cannot open the oven doors until the temperature drops to a safe/cool temperature.
• You should not operate cooktop burners during self-cleaning mode.
62
English
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 62-63
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 62-63
completely.
the Off position.
position.
Self clean.
<, > to select another time set. Press OK to start Self
Cleaning.
heat up. When the cycle is complete, an alert beep
sounds. The door will remain locked until the oven
temperature falls below 400 °F(205 °C).
mode selector knob to the Off position.
To cancel the self-cleaning cycle
You may find it necessary to stop or interrupt a self-cleaning cycle due to smoke in the
oven. To turn off the self-cleaning cycle, turn the mode selector knobs to the Off position.
The cycle turns off, but the door remains locked until the oven temperature falls below
400 °F (205 °C).
After self-cleaning
• The door stays locked until the internal oven temperature falls below 400 °F.
•
When the oven has cooled down, wipe the oven surfaces with a cloth to remove ash residue.
• Stubborn stains can be removed using a steel-wool pad. Lime deposits can be removed
using a vinegar-soaking cloth.
• If you are not satisfied with the cleaning results, repeat the self-cleaning cycle.
• The oven will not let you repeat a self cleaning cycle immediately You must wait 2 hours
before running self-cleaning again.
• Fine lines generated inside the cavity may occur during repeated cooling and heating
of the product after long-term use. This phenomenon is normal, does not affect product
performance, and is harmless to the human body.
CAUTION
Do not attempt to open the oven door immediately after the self-cleaning cycle is complete.
The oven is still very hot when the door unlocks. Escaping hot air or steam could burn you.
English
63
2023-01-17 오후 3:01:57
2023-01-17 오후 3:01:57
Publicité
