Festool PLANEX LHS 225 E Notice D'utilisation D'origine page 19

Customer service and repair. Only
through manufacturer or service work-
shops: Please fi nd the nearest address
at:
www.festool.com/Service
EKAT
4
Use only original Festool spare parts!
5
3
Order No. at: www.festool.com/Service
2
1
 To ensure constant air circulation, always keep
the air vent slits in the motor housing clean
and free of blockages. Read the instructions on
visual warning signals in chapter 8 "Operation".
 Clean the contact slide regularly. Do not use
hard objects.
The machine is equipped with self-disconnecting
special carbon brushes. If they are worn, power is
interrupted automatically and the machine comes
to a standstill.
 Tighten the clamping levers if they no longer
capable of retaining the extension pipe properly:
 Turn the screws on the clamping levers [2-1]
and [2-2] approx. 1/8 of a turn.
10 Accessories, tools
Use only original Festool accessories and Festool
consumable material intended for this machine
because these components are designed specifi -
cally for the machine. Using accessories and con-
sumable material from other suppliers will most
likely affect the quality of your working results and
limit any warranty claims. Machine wear or your
own personal workload may increase depending on
the application. Protect yourself and your machine,
and preserve your warranty claims by always using
original Festool accessories and Festool consum-
able material!
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under "www.festool.com".
13 Troubleshooting
Problem
P L A N E X bumps
over the surface.
Possible causes
Suction power too strong
Hard repair compound or hard sub-
layers
11 Disposal
Do not throw the power tool in your household
waste! Dispose of the machine, accessories and
packaging at an environmentally-responsible recy-
cling centre! Observe the valid national regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh:
www.festool.com/reach
12 EU Declaration of Conformity
Long reach sander
LHS 225 EQ P L A N E X
Year of CE mark: 2007
We declare under sole responsibility that this prod-
uct complies with the following norms or norma-
tive documents: EN 60745-1, EN 60745-2-4, EN
55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3
in accordance with the regulations 2006/42/EC,
2004/108/EC, 2011/65/EU.
Dr. Johannnes Steimel
Head of Research, Development and Technical
Documentation
Festool Group GmbH & Co. KG
Wertstraße 20
D-73240 Wendlingen
Remedy
Reduce suction power or switch to external
extraction if necessary.
Reduce suction power or switch to external
extraction if necessary.
Reduce speed.
Serial no.
492236, 494828
2014-06-26
19