Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
6 Piece Set
Remove tape liner from front flange of Extended Rear Visor. Peel
back 2" (5cm) of tape liner from each end of top and bottom
top flange
10
bottom flange
Gently press the exposed areas of tape against the surface and
verify position. With the visor in its final position, remove the re-
maining tape liner by pulling on free ends.
12
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms
of fit, durability, finish and ease of installation.
™
Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
flanges.
free ends
front flange
800-241-7219 • Visit us at lundinternational.com
© 2012 Lund International, Inc. All rights reserved.
, the Auto Ventshade
logo and the AVS
TM
TM
Align the deflector on the outside of the window frame. Align the
front of the Extended Rear Visor parallel to the previously installed
11
Apply pressure along all flanges to ensure proper adhesion of tape.
13
Repeat Steps 1 - 13 for opposite side.
Lund International
logo are trademarks of Lund International, Inc.
TM
Page 3 of 3
Rear Visor.
Publicité
