Publicité
Les langues disponibles
Les langues disponibles
NOTE: A correctly adjusted headrest ensures optimal protection of the child in the child
EN
restraint.
IMPORTANT: The lower edge of the headrest should be at a finger distance from the child's
shoulder.
ASSEMBLING AND DISASSEMBLING THE CHILD RESTRAINT
• To assembly, combine the base with the backrest, as shown in the picture. Make sure the
hooks are secured. Push the latches down until they click into place. Raise the support
back.
You will hear an audible CLICK!
• To disassembly, push the backrest down, lower the child restraint into a flat position,
as shown in the pictures.
be easily lifted out of the sockets on the rear of the booster seat.
backrest apart.
SEAT COVER REMOVAL
1.
Set headrest in the highest position.
2. Disassembly the child restraint. Refer to the ASSEMBLING AND DISASSEMBLING THE
CHILD RESTRAINT paragraph.
3. Remove the cover from the, headrest, backrest and
base.
To reattach the cover, reverse the above steps.
INSTALLATION
WARNING: If the child is not secured properly, the child could be ejected in a sudden stop
or crash, resulting in serious injury or death.
WARNING: If in doubt about the installation, consult either the child restraint manufacturer
or the retailer.
GROUP II (15-25 KG)
NOTE: Adjust, or remove, the vehicle headrest, in the seat where the child restraint is to be
fastened, so that the back of the child restraint rests against the vehicle seat-back.
1.
Place child restraint forward-facing (in the direction of travel) in proper seating
location, flat on the vehicle seat bottom and touching vehicle seat-back.
2. Press the ISOFIX button to pull out the two ISOFIX locking arms from the base bottom.
You will hear an audible CLICK!
means ISOFIX attachments are unlocked.
NOTE: The ISOFIX attachment points are located between the surface and the backrest
of the vehicle seat.
3. Align ISOFIX attachments to the metal anchorages at the bottom of the car seat's
backrest and push it until it clicks.
of the ISOFIX locking arms turn into green safety colour.
CAUTION: After the ISOFIX installation check if the child restraint is securely fitted. If the
child restraint is not stable and is shaking, reinstall.
4. To fasten seat belt across child: lap portion of the
vehicle seat belt should rest within both lower belt
guides with buckle located on the outside of the child
restraint. On the side of the seat belt buckle, route
the shoulder belt together with the lab belt under the
40
When unfolded, the hook at the bottom of the backrest can
Ensure that the indicator turns into a red colour, which
You will hear an audible CLICK! Ensure the both sides
Pull the seat and the
Publicité
