Publicité
Les langues disponibles
Les langues disponibles
Before Setting Oven
Controls
Oven Door Bracket
Adjustment
(some models)
All manuals and user guides at all-guides.com
Oven Vent Location
The oven is vented at the upper control panel or grille. When the oven is on, warm
air is released through the vent. This venting is necessary for proper air circulation
in the oven and good baking results. DO NOT block the vent. Doing so may cause
cooking failures, fire or damage to the wall oven.
Arranging Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING
THE OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the
rack forward until it stops. Lift up front
of rack and slide out. To replace an
oven rack, fit the rack onto the guides
on the oven walls. Tilt the front of the
rack upward and slide the rack back
into place.
The interior of a convection oven is shown in the above illustrations. As many as 3
racks may be supplied with convection models and 2 racks for other models.
If the oven door is too loose or too tight to open, it is possible to adjust it. There is
an adjustable bracket located on the front frame under the door on the handle side.
(See figure below)
To have an oven door opening loosens, push down the adjustable bracket and to
have it tighten, lift up the bracket.
9
To bake on one rack, place the
rack at position 3 or 4. To bake on
two racks, place the racks at
positions 2 and 4.
Publicité
