Publicité
Les langues disponibles
Les langues disponibles
Avoid Service Checklist
OCCURRENCE
Oven Control Beeps and Displays
-F1- or -F3-.
Oven is not level.
Entire appliance does not operate.
Oven light does not work.
All manuals and user guides at all-guides.com
Before you call for service, review this list. It may save you time and expense. The
list includes common occurrences that are not the result of defective workmanship
or materials in this appliance.
This oven is equipped with an electronic oven controller. Among its many features
is a full time oven circuit diagnostics system. The controller constantly monitors its
internal circuitry as well as several crucial oven circuits, to insure they are all
operating correctly. If at any time one of these systems fail, the controller will
immediately shut down operation, and will beep and flash an error code of -F1- or
-F3- in the display window.
POSSIBLE CAUSE/SOLUTION
Electronic control has detected a fault condition. Push the CANCEL pad to clear the
display and stop the display from beeping. Reprogram the oven. If a fault reoccurs,
record the fault number, push the CANCEL pad and contact an authorized servicer.
Poor installation.
installing agent if rack is not level; unit may be shimmed underneath.
When the oven is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash.The oven cannot be programmed until the clock
is set.
Make sure electrical cable is securely connected and grounded into electrical circuit.
Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
Power outage. Check house lights to be sure. Contact your local electric company.
Short in electrical cable. Contact your dealer, installing agent or authorized servicer.
Electronic controls are not set properly. See instructions under Setting Oven
Controls or Oven Cleaning.
House fuse has blown or circuit breaker has tripped immediately following installation.
House fuse may not be fully engaged. Check fuse or engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been installed
and previously operating. Call an authorized servicer.
Burned out or loose bulb. Follow instructions under Changing Oven Light to
replace or tighten the bulb.
1 9
Place a level on an oven rack in center of oven. Contact
Publicité
