Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
4
By using the proper template provided with
KIT KR56, make the 4 holes for the dowels (1)
and the central hole for the shaft.
Make also the two holes with Æ 4 mm to
5
fix the bezel on the dashboard. (If necessary,
remove the pump to facilitate the operations).
6
Place the pump (2) on the back side of the
dashboard (4) and fix it by using the 4 nuts (5)
and the washes (6) as indicated in the picture.
Put medium-strength threadlocker like Loctite
243 (or similar) on the dowels (1) and tighten
the nuts with a torque of 25 Nm (18,45 lb ft) by
using an open end wrench 19 mm.
WARNING
Install the helm with the filling cap (7) in up
position (like the picture) for the correct working
of the pump and to allow filling and bleeding
the system completely (see par. 3.7).
7 Insert the supplied O-ring on the back side of the bezel.
8 Insert the bezel (8) on the shaft (9) and lock it by means of the
two self-tapping screws (10).
Installation and Maintenance Manual
1
4
5
8
PUMP FOR HYDRAULIC SYSTEMS
7
2
1
6
9
10
page 13
-
of 75
Publicité
