Télécharger Imprimer la page

Parkside PSSA 3.6 C4 Traduction Des Instructions D'origine page 38

Publicité

Les langues disponibles

Les langues disponibles

GB
Charging process
Do not expose the battery to
extreme conditions such as
heat and impact. There is a
risk of injury from leaking
electrolyte solution! In case
of contact, rinse with water
or neutraliser and consult a
doctor if contact has occurred
with eyes etc.
Charge the battery only in
dry areas.
There is a risk of injury from
electric shock.
The device may only be powered with
SELV (Safety Extra Low Voltage) as
marked on the device.
Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short pe-
riods in succession.
To charge the Li-ion battery integrated
in the appliance, use the battery charg-
er supplied.
In all cases, observe the applicable
safety information as well as the regu-
lations and directions for environmen-
tal protection.
Defects resulting from improper han-
dling are not subject to the guarantee.
Charging the battery
1. Connect the charging cable con-
nector (12) with the charging
socket (7) of the device.
2. Plug the charger (
electrical outlet.
3. The battery indicator (3) lights
up:
38
All manuals and user guides at all-guides.com
13) into an
red => Start of charging
red and yellow =>
Battery appr. half charged
red-yellow-green =>
Battery fully charged.
4. After the charging process,
disconnect the charger (
from the mains supply.
Initial Operation
Switching ON and OFF
1. Press the on/off switch (8) to
start the device. The LED work
light (10) lights up during opera-
tion.
2. To turn it off, release the on/off
switch (8).
Overload protection: The safety cut-off of
the device switches off in case of overload.
Release the On/Off switch, the device can
be switched on again after a few seconds.
Checking the charge status
of the rechargeable battery
The battery indicator (
state of charge of the battery.
Press the On/Off switch, the state of
charge of the battery is displayed by
turning on the 3 coloured LED lights:
red-yellow-green =>
Battery fully charged
red and yellow =>
Battery appr. half charged
red =>
Battery is empty, please charge.
13)
3) signalises the

Publicité

loading