Black & Decker BDOJ620 Traduction Des Instructions D'origine page 25

Variable speed control
♦ Use a high speed for wood, medium speed for
aluminium and PVC and low speed for metals
other than aluminium.
Switching on and off
♦ To switch the tool on, press the variable speed
switch (1). On BDOJ620 units the speed
depends on how far you depress the switch.
♦ For continuous operation, press the lock-on
button (2) and press the variable speed switch.
This option is available only at full speed.
♦ To switch the tool off, release the variable
speed switch. To switch the tool off, when in
continuous operation, press the variable speed
switch once more and release it
How to Use the Sightline
♦ Use a pencil to mark the cutting line.
♦ Position the jig saw over the line (11).
Viewing from directly above the jig saw, the line of
cut can be followed easily.
Cutting mode
Pendulum stroke or action provides a more
aggressive blade motion and is designed for
cutting soft materials such as wood or plastic. It
provides a faster cut, but with a less smooth cut
across the material. Dependant on model, your jig
saw will have either a Pendulum Stroke dial or an
Auto Select dial to set the pendulum action. Use of
these dials is explained in the next two sections.
Note: Never use pendulum action to cut metal.
PVC
All manuals and user guides at all-guides.com
Feature (fi g. D)
®
Icon Speed
Slow
Medium
PVC
Fast
Fast
Fast
(Original instructions)
Pendulum Stroke dial (fi g. E)
The BDOJ620 has these four cutting modes with
increasing amounts of pendulum action:
♦ Position 0: metal and aluminium and sheet
metal (no pendulum action).
♦ Position 1: for laminates, hard wood, work tops.
♦ Position 2: for plywood and PVC/Plastics.
♦ Position 3: for soft wood and fast cutting
To adjust the pendulum action:
♦ Rotate the Pendulum Stroke dial (6) to the
required position.
Sawing
Hold the tool fi rmly with both hands while cutting.
The shoe plate (4) should be held fi rmly against
the material being cut. This will help prevent
Auto Select™ dial (fi g. F)
The KS801SE/KS901SE are fi tted with a unique
Auto Select™ Dial (6) to set the speed and the
pendulum action for various cutting applications. To
select the optimum speed and pendulum action for
the type of material being cut, rotate the dial (6) as
shown in the table below:
Pendulum
Straight and curved cuts - sheet
No metal, tin plate, ceramic tiles and
fi breglass sheet
Straight and curved cuts - hardwood,
Medium/low decking, fl ooring, plastic, pexiglas and
PVC
Straight cuts – general lumber and
Maxiumum
softwood
Straight and curved cuts – plywood
Medium/low
and wood panels
Straight and curved cuts –
No countertops, laminate boards,
scrolling, curves and craftwork
ENGLISH
Application
25