Francepower FP 1000 Manuel D'utilisation Et D'entretien page 52

Groupes Electrogènes FP 1000 Inverter et FP 2000 Inverter
equipment works well before connecting. If the running of the equipment is
abnormal, the speed decreases, or the machine suddenly stops working, you
should turn off the engine immediately, disconnect it from the circuit, and
examine it to find out the breakdown.
The outputting and overloading indicator lights
If the generator is in a good working order, the outputting indicator light (green)
is on. If the generator overloads ( over 2KVA), or in case of a short circuit inside
the electrical machine it links to, the outputting indicator light (green) will turn off,
while the overloading indicator light (red) will lighten. At this time, the current to
the linked electrical equipment will be cut off. If the red indicator light is on, you
should turn off the engine, and examine why it is overloaded.
Before you link the wire to the generator, first examine if it is in good working
order, and whether its electric power level exceeds the generator capacity or not.
Then engage the cable of the electrical equipment and start the generator.
1 – Overload (RED)
Warning:
After the generator starts up, the red light and the green light may shine at the
same time, if the red light goes out, it is normal. If the red light still shines,
please inquire the generator agent.
Use of the continuous current
The continuous current AC socket is only applicable to charge the battery (12V).
Attention
During the operation process of the direct current, turn the intelligent fuel-
saving valve to the "CLOSE" position.
First connected the charging cable (Fig. A) to the direct current socket of the
2 – Outputting (GREEN)
52