Adler europe AD 4811 Mode D'emploi page 3

ENGLISH
GENERAL SAFETY CONDITIONS
IMPORTANT INSTRUCTIONS FOR SAFE USE
READ CAREFULLY AND SAVE FOR FUTURE
1. Before using the device, read the operating manual and follow the instructions contained
in it. The manufacturer is not liable for damages caused by using the device contrary to its
intended purpose or improper operation.
2. The device is for home use only. Do not use for other purposes that are not for its
intended purpose.
3. The device should only be connected to a 220-240 V ~ 50 Hz grounded socket.
To increase operational safety, multiple electrical devices should not be connected to one
current circuit at the same time.
4. Use extreme caution when using the device when children are nearby. Do not allow
children to play with the device, do not allow children or people unfamiliar with the device
to use it.
5. WARNING: This equipment may be used by children over 8 years of age and people
with reduced physical, sensory or mental ability, or people who have no experience or
knowledge of the equipment, if this is done under the supervision of a person responsible
for their safety or have been granted them information on the safe use of the device and
are aware of the dangers of using it. Children should not play with the equipment. Cleaning
and maintenance of the device should not be performed by children, unless they are over 8
years old and these activities are carried out under supervision.
6. Always remove the plug from the wall socket by holding the socket with your hand after
use. DO NOT pull on the power cord.
7. Do not immerse the cable, plug and the whole device in water or any other liquid. Do not
expose the device to atmospheric conditions (rain, sun, etc.) or use in conditions of high
humidity (bathrooms, damp mobile homes).
8. Periodically check the condition of the power cord. If the power cord is damaged, it
should be replaced by a specialist repair shop to avoid danger.
9. Do not use the device with a damaged power cord or if it has been dropped or damaged
in any other way or if it is not working properly. Do not repair the device yourself, as there
is a risk of electric shock. Take the damaged device to an appropriate service center for
checking or repair. All repairs may only be carried out by authorized service points.
Incorrectly performed repairs can cause serious danger for the user.
10. Place the device on a cool, stable surface, away from heating kitchen appliances such
as: electric stove, gas burner, etc.
11. Do not use the device near flammable materials.
12. The power cord may not hang over the edge of a table or touch hot surfaces.
13. Do not leave the device plugged into the wall socket unattended.
14. To provide additional protection, it is advisable to install a residual current device (RCD)
in the electric circuit with a rated residual current not exceeding 30 mA. Ask an electrician
for this advice.
15. The device and its equipment must not be exposed to high temperatures (above 60 °
C).
16. A change of accessories can only be made with the device switched off.
17. The milling assembly must be carefully assembled. Inaccurately twisted can cause
poor grinding quality and cause blunting of the blade and strainer.
18. Use only original accessories supplied with the device.
19. Do not overload the device with excessive amounts of product or pushing it too hard.
Only use the pusher for pushing. Using other objects can damage the razor.
20. Meat intended for grinding should be separated from bones, cartilage, cleaned of
tendons and veins. Cut larger portions into pieces.
3