Publicité
Les langues disponibles
Les langues disponibles
How to Use
EN
One-Press Self-Cleaning
1. Place the appliance back onto the base while you finish cleaning. Ensure that the water
in the Clean Water Tank is sufficient for self-cleaning.
2. Briefly press the self-cleaning button on the top of the handle, the self-cleaning
indicator will light up, and the appliance will start self-cleaning.
3. Please empty the Used Water Tank after self-cleaning is completed and drying mode
has been engaged. Press the button
Note: The self-cleaning function can be enabled only when the appliance is being charged and the
battery level is more than 15%.
Drying Mode
Press and hold self-cleaning button
1.
seconds to activate drying mode.
The appliance will be charged once drying
2.
is completed.
minimum water level of self-cleaning
Minimum Water Level of Self-Cleaning
Note:
• After self-cleaning is complete, promptly clean the Used Water Tank. Clean the charging base if
there are any stains left on the base.
• If cleaning the brush roller manually, please air-dry it thoroughly or dry it by using drying mode
several times to ensure a good drying effect.
11
11
to exit the drying mode.
for 3
Care & Maintenance
Tips:
• Turn off the appliance before maintenance. Do not touch the power switch.
• Replace parts if needed. The parts must be replaced by those available from the
manufacturer or its service agent.
• If the vacuum is not used for an extended period, fully charge it, unplug the power plug,
and store the vacuum in a cool, low-humidity environment away from direct sunlight. To
avoid over-discharge of the battery, charge the vacuum at least once every 3 months.
Cleaning the Used Water Tank and the Filter
1. Press the Used Water Tank release
button, and pull the Used Water Tank
outwards to remove it.
2
1
3. Rinse the Used Water Tank and the tank
cover with clean water. Clean the tank by
the provided cleaning brush.
Note:
• If the filter is dirty, rinse it with clean water and dry it completely before use.
• Replacing the filter every 3 to 6 months is recommended.
2. Take out the filter from the Used Water
Tank cover. Remove the tank cover and
empty the tank.
Filter
Used Water
Tank Cover
4. Re-install the filter and the Used Water
Tank cover. Then re-install the Used Water
Tank until you hear a click.
Click
2
1
EN
12
12
Publicité
