Publicité
Les langues disponibles
Les langues disponibles
Installation
EN
Storage Box Installation
Install the storage box onto the
charging base as shown in the diagram.
Assembly and Disassembly of Handle
Insert the end of the handle vertically into the port on the top of the vacuum as
indicated until you hear a click.
Click
Note: To disassemble, press the contacts in the hole on the back of the appliance with the
appropriate tool and pull the handle upwards at the same time.
7
7
Charging
1.
2.
2
1
Note:
• If there is no operation within 10 minutes of being fully charged, the vacuum will enter sleep
• To extend the battery life time, the battery keeps cooling down for about one hour automatically
Place the charging base against a wall on level ground and connect it to a
power source. Fully charge the appliance before first use.
Place the appliance on the charging base. When the voice prompt "Charging Started"
is displayed, the appliance activates the charging mode. When charging, the number
on the display screen represents the current battery level as a percentage. When the
number reaches 100, the battery is fully charged.
mode. Please restart the appliance if you need to use it.
after you have used the appliance for a long time.
EN
8
8
Publicité
