Playing Discs; Playing A Disc; Selecting The Playback Layer - Sony SDC-XA1200ES Mode D'emploi

Playing Discs

Playing a Disc

The operations for normal play and the basic
operations during play are explained below.
1
Turn on the amplifier. Turn down the
volume level to the lowest.
2
Select the player position using the
input selector on the amplifier.
3
Press POWER on the player to turn on
the player.
4
Press A on the player to open the disc
tray, and place a disc on the tray.
With the label side up
5
Press N.
Playback starts from the first track. If you
want to start playing from a specific track,
turn . AMS > to select the track
number before pressing
6
Adjust the volume on the amplifier.
Basic operations during play
To
Stop play
Pause play
Resume play
after pausing
Select a track
Eject a disc
Tip
If you turn on the player when a disc is already loaded,
playback starts automatically. If you connect a
commercially available timer, you can set it to start
playing the disc at any time you want.
GB
10
N .
Do the following:
Press x.
Press X.
Press X or N
.
Turn . AMS >.
Press A on the player.
Note
During playback, increase the volume level gradually
starting from the lowest level. The output from this
player may contain band width that is out of the normal
listening range. This may cause damage to the speakers
or ears.
Locating a track directly by
entering the track number on
the remote
Press the number button(s) to enter the
track number.
To enter a track number over 11
1
Press >10.
2
Enter the corresponding digits.
To enter 0, press 10/0 instead.
Examples:
• To play track number 30, press >10, then
3 and 10/0.
• To play track number 100, press >10
twice, then 1, and 10/0 twice.
Note
The default display reappears if you press >10 twice
when the number of total tracks is less than 100.

Selecting the playback layer

When playing a hybrid disc with a Super Audio
CD layer and a CD layer (page 5), you can select
the layer you want to listen to. Also, since both
layers are on one side, it is not necessary to turn
the disc over.
Press SA-CD/CD to select the desired
playback layer.
To select the default playback
layer
1
Press MENU on the player.
2
Turn . AMS > until "LAYER SEL"
appears in the display.
3
Press . AMS >.
The current default layer appears.
4
Turn . AMS > to select the
desired playback layer.
5
Press . AMS >.