Troubleshooting - Sony SDC-XA1200ES Mode D'emploi

Troubleshooting

If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help you remedy the
problem. Should any problem persist, consult
your nearest Sony dealer.
There is no sound.
• Check that the player is connected securely.
• Make sure you operate the amplifier correctly.
There is no sound from the DIGITAL (CD) OUT
COAXIAL/OPTICAL connectors.
• The audio signals of the Super Audio CD cannot
be output from the DIGITAL (CD) OUT
COAXIAL/OPTICAL connectors.
The disc does not play.
• There is no disc inside the player.
• Place the disc on the disc tray with the label side
up.
• The disc is placed at an angle. Reload the disc.
• Clean the disc (see page 21).
• Moisture has condensed inside the player.
Remove the disc and leave the player turned on for
about an hour.
• There is an incompatible disc on the tray (see
page 4).
The remote does not function.
• Remove any obstacles in the path of the remote
and the player.
• Point the remote at the remote sensor on the
player.
• If the batteries in the remote are weak, replace
with new ones.
• The command mode of the player is set to CD2
(page 9).
There is no sound from the SUB WOOFER
jack.
• Select a playback mode in which the sub woofer
signal is output from the SUB WOOFER jack.
The mode indication is displayed with "+ SW"
(page 16) when such a mode is selected.
• When you play a track that does not contain the
LFE signal, the signal outputs from the SUB
WOOFER jack only when you select "5–
SMALL+SW" or "F–LARGE+SW" for Multi-
channel mode (page 16).
GB
22
A disc cannot be ejected and "LOCKED"
appears in the front panel display.
• Contact your Sony dealer or local authorized Sony
service facility.
After you have attempted the
prescribed corrective actions
If the player still does not operate properly, or if
other problems not described above occur, turn
off the player, unplug it from the power outlet
for a few minutes, then reinsert the plug into the
power outlet.