Publicité
Les langues disponibles
Les langues disponibles
56 electrolux
What to do if ...
Troubleshooting by yourself
1)
Problem
Dryer not connected to mains supply.
Dryer does
not work.
Loading door opened.
The START PAUSE button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Unsatisfactory
Max. loading exceeded.
drying results.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Loading door
Filters not locked in place.
does not close
Err ( Error ) on
Attempt to change parameters after start
5)
of the programme.
the LCD.
Programme selector in OFF position.
No drum light
Defective light bulb.
Abnormally
Time to end is calculated on the basis of:
elapsing time
type, volume and dampness of laundry.
5)
on the LCD
Programme
Full water reservoir.
inactive
Drying cycle
Small laundry volume./Too dry laundry for
to short
selected programme.
Fluff filters clogged.
To high loading volume.
Drying cycle
Laundry insufficiently spun.
6)
to long
Particularly high room temperature - no
machine fault.
1) In case of error message on the LCD (e.g. E51 - only dryers with the LCD): Switch the dryer off and
on. Set programme. Press the START PAUSE button. Does not work? - inform local service and quote
the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaning chapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Changing the bulb for interior lighting
Only use a special bulb which is designed specially
for dryers. The special bulb can be obtained from
your local service centre.
All manuals and user guides at all-guides.com
Possible cause
Important! When the appliance is switched on,
the interior lighting switches itself off after 4
minutes when the door is open.
Remedy
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door
Press the START PAUSE button.
Set suitable programme.
3)
Clean fluff filters.
3)
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course filter
into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to DRUM LIGHT (if available) or to
any programme.
Replace light bulb (see next section).
Automatic process; this is not a machine
fault.
3)
Empty water reservoir
PAUSE button.
Select time programme or higher drying
level (e.g. EXTRA DRY).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
2)
4)
.
, press START
Publicité
