Troubleshooting - Ryobi DP103L Manuel D'utilisation

Problem
Noisy operation
Bit burns or smokes
Excessive drill runout or wobble
Drill bit binds in workpiece
Workpiece support loosens

TROUBLESHOOTING

Possible Cause
Incorrect belt tension.
Dry spindle.
Loose spindle pulley or motor pulley.
Incorrect speed.
Chips not coming out of hole
Dull bit.
Feeding too slow.
Not lubricated.
Bent bit.
Bit not properly installed in chuck.
Chuck not properly installed.
Worn spindle bearings.
Excessive feed pressure.
Improper belt tension.
Workpiece not supported or clamped
properly.
16 - English
Solution
Adjust belt tension.
Lubricate spindle.
Tighten set screws in pulleys.
Change speed. See "Changing
Speeds" in the Adjustments section.
Retract bit frequently to clear chips
Sharpen or replace bit.
Feed fast enough; allow drill to cut.
Lubricate bit for metal work.
Replace bit.
Install bit properly.
Install chuck properly.
Contact authorized service center.
Reduce feed pressure.
Adjust belt tension.
Check support and/or reclamp
workpiece.