Télécharger Imprimer la page

Stihl FSE 60 Notice D'emploi page 15

Masquer les pouces Voir aussi pour FSE 60:

Publicité

Les langues disponibles

Les langues disponibles

Storing the Machine
If not used for periods of about 30 days
or longer
Thoroughly clean the machine,
N
especially the ventilation slots
Take out the spool with mowing
N
lines and engage the ends of the
lines in the spool's notches. Clean
and inspect the spool.
The resilience and service life of the
mowing line can be increased by storing
it in a container filled with water.
Store the machine in a dry and
N
secure location. Keep out of the
reach of children and other
unauthorized persons
FSE 60
Maintaining the Mowing
Head
Placing Power Tool on the Ground
Switch off the power tool.
N
Lay your trimmer on its back with
N
the loop handle facing down and the
output shaft facing up.
Re-Adjusting the Mowing Line
2
1
hold the rotating mowing head
N
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
The blade (1) on the deflector (2)
N
trims surplus mowing line to the
correct length – avoid tapping the
mowing head more than once at a
time!
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
If the line is shorter than 2.5 cm:
WARNING
To reduce the risk of injury, always shut
off the engine before adjusting the nylon
mowing line by hand.
Lay your trimmer on its back, make
N
sure it is secure.
Press down the cap on the spool as
N
far as stop.
Pull the ends of the lines out of the
N
spool.
If the spool is empty, refill with mowing
line
Replacing the Mowing Line
Always check the mowing head for wear
before replacing the mowing line.
WARNING
If signs of heavy wear are visible, the
mowing head must be completely
replaced.
The mowing line is referred to as 'line' in
the following.
An illustrated guide to replacing lines is
supplied with the mowing head. So keep
the instructions for the mowing head in a
safe place.
Remove the mowing head if
N
necessary
English
13

Publicité

loading