Stihl FSE 60 Notice D'emploi page 13

STIHL AutoCut C 6-2
Place the mowing head (2) on the
N
shaft (3) while inserting the internal
hexagon (2) on the hexagon (4)
Hold the mowing head (2) with your
N
hand.
Turn cap (1) clockwise and tighten it
N
firmly by hand.
Removing the Mowing Head
Hold the spool housing steady
N
Unscrew the cap counterclockwise.
N
FSE 60
Connecting to Power Supply
1
The voltage and frequency of the
machine (see rating plate) must match
2
the voltage and frequency of the power
connection.
The minimum fuse protection of the
3
power connection must comply with the
specifications – see "Specifications".
4
The machine must be connected to the
power supply via an earth-leakage
circuit breaker to disconnect the power
supply if the differential current to earth
exceeds 30 mA.
The power connection must correspond
to IEC 60364 and relevant national
regulations.
Extension Cords
120 V version
Minimum wire gauge for extension
cords for 120 Volt appliances using
0 - 6 amps:
Cord length (ft)
Wire size (AWG) 18 16
230 V version
Minimum cross sectional area of wires:
Cord lengths of 6,5 ft (2 m) or more:
2
1,5 mm , type H07 RN-F
N
Strain relief clamp, strain relief flap
(supports extension cord and reduces
the likelihood of disconnection of
extension cord receptacles and trimmer
plug)
The strain relief (cable retainer) protects
the connecting cable from damage.
25 50 100 150
16 14
N
N
N
N
1 2
Insert the plug (1) into the extension
cord coupling (2)
3
5
4
make a loop (3) in the extension
cord
Pass the loop (3) through the
opening (4)
Slip the loop (3) over the hook (5)
and pull it tight
Plug the extension cord into a
properly installed outlet
English
11