FONtevo COMpact 4000 Notice D'utilisation page 49

ISDN Terminal at the Internal U
Connection possibilities:
• System telephones COMfortel 1200/1400/1600/2600 (firmware version 1.6A or later)
• ISDN telephones in accordance with the Euro ISDN Standard (DSS1)
• ISDN PC controllers in accordance with the Euro ISDN Standard (DSS1)
Requirements:
• Enabled operating mode "U
• Enabled terminators in the PBX at the internal U
operating mode "U
If the terminals and the PBX have a short distance
to each other, connect a single COMfortel 1200/
1400/1600/2600 system telephone directly to the
RJ-45 socket of the internal U
ISDN terminals or two system telephones per port
you require a U /S
P0 0
If the distance between PBX and terminal is greater,
lay the lines fixed at the terminal clamps of the
internal U port.
P0
Caution: Terminals integrated in the wall sockets are destroyed and can damage the
device.
• Contrary to the S
already integrated in the terminals (COMfortel 1200/1400/1600/2600 or U
• Remove terminals which have already been integrated in the wall sockets for use at the
U port.
P0
Note: You do not need an ISDN wall socket if you use a U
Adapter can be mounted on the wall or it can be connected to the PBX via the two screw
terminals on the back.
COMpact 4000 Instructions V04 03/2017
Port
P0
internal" at the U
P0
internal"
P0
port. For all other
P0
Adapter.
port, do not equip a line at the U
0
port in question
P0
port in question
P0
terminators enabled
internal U port
P0
IAE/UAE8
port with terminals. These are
P0
/S Adapter. The U
P0 0
Installation
/S Adapter.
P0 0
/S
P0 0
49