FONtevo COMpact 4000 Notice D'utilisation page 43

Notes: The behaviour of COMfortel 1400 IP/2600 IP/3200/3500/3600 IP telephones when
numbers are being dialled depends on the set default account (see telephone's instructions).
For COMfortel 1400 IP/2600 IP/3600 IP telephones as of firmware version 2.4, the default
account can be taken over from the PBX if the telephone is a system telephone and is thus
set dependent on the type of exchange line request.
To avoid conflicts between 3 or 4 digit phone numbers of the local area network and the
internal numbering plan, phone numbers of the local area network should always be dialled
with local area code.
Also when the entered phone number correspond with the internal telephone numbering
plan, the PBX waits up to 4 seconds for whether additional digits for an external number are
being entered, before it dials the internal phone number. To avoid waiting time, you can
subsequently enter #. The PBX therefore recognises the input as finished and instantly starts
dialling.
Emergency Calls
The emergency numbers set up on the PBX are used for emergency calls. These calls are
handled in a special way.
Note: One of the basic settings is the setting of the country where the PBX is located. By this
setting the public emergency numbers of the selected country are automatically entered in
the configuration.
Emergency calls can be made without dialling an exchange line access number that is
necessary for other calls (factory setting). This has the benefit that even people who do not
know how to use exchange line access numbers can make emergency calls.
If the emergency call priority switch is enabled (factory setting), emergency calls have priority
over other calls. If necessary, a call can be interrupted to enable an emergency call to be
made.
A system telephone can also be used to make emergency calls if the screen lock is switched
on (optional, see telephone's instructions).
Installation
Warning: Power surges, which can occur during electrical storms, can cause life-
threatening electric shocks and can damage or destroy the PBX.
• Do not touch the PBX or any devices connected to it during an electrical storm.
• Hire a qualified electrician to lay the cables within the building – including the cable to the
door terminal.
• Do not use the a/b ports to connect remote extensions.
COMpact 4000 Instructions V04 03/2017
Installation
43