FONtevo COMpact 4000 Notice D'utilisation page 46

Installation
Connection possibilities:
• Public analogue telephone network across Europe
• Analogue GSM gateway
If the analogue connection has a greater distance to the
PBX, a cable with a wall socket at the terminal clamps of
the external analogue port must be laid fixed. Connect
the devices with the RJ-11/RJ-11 connection cable
included in the scope of delivery. Within Germany, you
additionally require the RJ-11/TAE-F adapter.
Internet and VoIP Terminals as well as PC at the Ethernet Port
Connection possibilities:
• PC
• Internet (VoIP accounts with one or more VoIP phone numbers similar to the PMTP
connection on ISDN and VoIP accounts with an extensions block similar to the PBX
connection under ISDN, based on the SIP-DDI feature (also known as SIP trunking)
• COMfortel 1400 IP/2600 IP/3600 IP system telephones
• COMfortel 3200/3500 system telephones (firmware version 1.8E or later)
• IP DECT single- and multicell servers COMfortel WS-400 IP and COMfortel WS-650 IP
for COMfortel M-100, COMfortel M-200/210 and COMfortel M-300/310 DECT handsets.
• Standard VoIP telephone (SIP), e. g. COMfortel 1200 IP
• Softphones (SIP)
• IP switch relays (e.g. NETIO 230B, WebRelay (identical to Keil), Energenie EG-PM2-Lan,
Philips hue)
• IP door terminals (e.g. Telecom Behnke Serie 20 IP, Baudisch SIP door terminal Maxi,
TCS FBI 6101, ELCOM LBM-300)
Requirements:
• For Internet access: Broadband Internet connection (e. g. DSL router, TV cable router)
• Existing network (LAN) or single switch (for VoIP terminals) with a data transmission rate
of 100 Mbit/s
Notes: For VoIP data communication in combination with the transmission of limited
amounts of data, a data transmission rate in the LAN of 10 Mbps is sufficient under certain
circumstances. For VoIP data communication in combination with the transmission of large
amounts of data (e. g. downloads), we recommend upgrading to a data transmission rate of
100 Mbps. For this purpose, replace not only all of the active network components (e. g.
switch and router), but also all of the passive network components (e. g. cables and wall
sockets). For a reliable support of 100 Mbps, you need cables and wall sockets of at least
Category 5 (CAT 5).
46
external analogue port
RJ-11 wall socket
COMpact 4000 Instructions V04 03/2017