FONtevo COMpact 4000 Notice D'utilisation page 45

Network Provider at the External S
Connection possibilities:
• NTBA
• Digital GSM gateway
• Router with internal S
• VoIP/ISDN adapter
Requirements:
• Enabled operating mode "S
• Terminators enabled at both ends of the connection – in the NTBA and in the PBX on the
external S port in question
0
operating mode "S
If the NTBA only has a slight distance to the
PBX, make a direct connection via the RJ45
socket (cable in the scope of delivery).
If the NTBA has a greater distance to the
PBX, then a cable must be laid fixed on the
terminal clamps of the external S
Network Provider at the External Analogue Port
Warning: Voltages that run through the connection socket of the network provider can
cause life-threatening electric shocks.
• Do not connect the PBX until the casing on the connection socket of the network provider
is closed again.
COMpact 4000 Instructions V04 03/2017
Port
0
port
0
external" on the S
0
external"
0
port.
0
port in question
0
terminators enabled
NTBA
Installation
external S port
0
45