FONtevo COMpact 4000 Notice D'utilisation page 40

Commissioning
Closing the Casing
Important: Before closing the casing, secure the Ethernet cable with
a cable tie to one of the straps provided for strain relief.
Note: The connections for the first commissioning (connection to a
PC/network and, if necessary, connection of a few terminals) must be
made before the casing is closed. Alternatively, you can prepare
them by laying a connecting cable that leads out of the housing.
Requirements:
• Cables carefully reinserted into
the cable space after
installation
1. Place the upper edge of the
cover onto the top of the
casing.
2. Press the lower edge of the
cover against the casing until it
clicks into place.
Turning on the PBX
Warning: Touching voltage-carrying conductors or telephone connections can cause
life-threatening electric shocks.
• Close the casing before you put the PBX into operation.
Requirements:
• PBX connected to earthing and casing closed
Connect the PBX to a freely accessible Schuko socket.
The Power and Status LEDs light up several seconds/minutes
in red and orange.
When the LEDs light up in green, the PBX is ready for operation.
Note: If the Power LED remains continuously lit in red, an error has occurred. Please contact
your dealer or the manufacturer directly.
40
COMpact 4000 Instructions V04 03/2017