Warning - Sony PlayStation 3 Sécurité Et Support Technique

WARNING

To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified personnel
only.
Caution
Use of controls or adjustments or performance of
procedures other than those specified herein
may result in hazardous radiation exposure.
The use of optical instruments with this product
will increase eye hazard.
This appliance is classified as a CLASS 1 LASER product under
IEC60825-1:2007.
2
FCC and IC notice
This equipment complies with FCC/IC radiation exposure limits
set forth for an uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines in Supplement C to
OET65 and RSS-102 of the IC radio frequency (RF) Exposure
rules. This equipment should be installed and operated with at
least 20 cm (8 in) and more between the radiator and person's
body (excluding extremities: hands, wrists, feet and ankles).
This transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
The wireless controller complies with FCC/IC radiation exposure
limits set forth for uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines in Supplement C to
OET65 and RSS-102 of the IC radio frequency (RF) Exposure
rules. This equipment has very low levels of RF energy that are
deemed to comply without testing of specific absorption rate
(SAR).
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.