Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
3
Technical Characteristics
3.1
Technical specifications, dry diamond drill type
Dry diamond drill type
Manufacturer
Operating voltage (V / Hz)
Power consumption (watt)
Protection class
No-load speed (min
-1
)
1)
Core drill bit diameter (mm)
Bit holder
2)
Weight (kg)
Speed electronics
3)
Sound measurement
L
(sound pressure) dB (A)
pA
L
(sound power) dB (A)
WA
Vibration measurement (m/s
The given speeds are to be viewed as maximum speeds for the given diamond drill bit diameters.
1)
Depending on the property of the material to be drilled, such as concrete with steel reinforcement of dif-
ferent thicknesses, the speed is set "by feel". When drilling through concreted-in steel with large diamond
drill bit diameters the 1st gear is always set.
Weight according to EPTA procedure 01/2003.
2)
3)
Measured values for noise determined according to EN 60745. Wear hearing protection!
4)
Total vibration values (vector sum in three directions) determined according to EN 60745
The vibration emission values given in this instruction manual have been measured according to a meth-
od of measurement standardised in EN 60745 and can be used for comparison between power tools. They
are also suitable for a preliminary estimate of the vibratory stresses.
The vibration emission values given represent the main applications of the power tool. If the power tool is
used for other applications, with different insert tools or are insufficiently serviced, this can significantly in-
crease the vibratory stresses over the whole work period. For a precise estimate of the vibration emission
values, the times during which the tool is switched off or is running but not actually in use should also be
taken into account. This can reduce the vibration stresses over the whole work period significantly.
WARNING
Health risk due to vibrations.
Î Additional safety measures should be taken to
protect the user, e.g. wearing anti-vibration pro-
tective gloves, correct maintenance of power
tools and insert tools, keeping hands warm and
good organisation of work sequences.
| 38 |
K = 3 dB
2
4)
)
K = 1.5 m / s
Maschinenfabrik OTTO BAIER GmbH
~230 / 50 / 60
1st gear
725
80 – 202
1¼ UNC and G½
2
BDB 829
2150
/ II
2nd gear
1500
42 – 80
6.6
Yes
91
101
5.5
Publicité
Table des Matières
