Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Contents
1
About this instruction manual ........... 31
1.1
Important information ............................. 31
1.2
2
Safety Instructions .............................. 31
2.1
Workplace safety .................................... 32
2.2
Electrical safety ...................................... 32
2.3
Safety of people ...................................... 32
2.4
Using and handling the power tool ......... 33
2.5
Service .................................................... 33
2.6
2.6.1
Operating personnel requirements ........ 33
2.6.2
Workplace safety .................................... 33
2.6.3
Electrical safety ...................................... 34
2.6.4
Safety of people ...................................... 34
2.6.5
power tool ............................................... 35
2.6.6
drill stand ................................................ 36
2.6.7
Service / Maintenance / Repair .............. 37
2.6.8
machine .................................................. 37
3
Technical Characteristics ................... 38
3.1
drill type .................................................. 38
3.2
3.3
EC Declaration of Conformity ................ 39
3.4
Machine characteristics ......................... 39
3.5
Machine parts and controls .................... 39
3.6
Intended use ........................................... 40
4
Before Starting Work ........................... 40
5
Held Operation ..................................... 41
5.1
5.2
Connect dust extractor .......................... 42
5.3
5.4
and drilling .............................................. 42
5.5
Ending the drilling process ..................... 44
6
Stand-Guided Drilling .......................... 44
6.1
6.1.1
Fixing onto the wall ................................. 44
6.1.2
kit (accessory) ........................................ 44
6.2
Adjusting the tilt at the drill stand ........... 45
6.3
drill stand ................................................ 45
6.4
Set guide clearance on spindle head ..... 45
6.5
and drilling .............................................. 46
6.6
Ending the drilling process ..................... 46
7
Cleaning ................................................. 47
| 30 |
8
Maintenance .......................................... 47
9
Handling Diamond Core Drill Bits ...... 48
10
Disposal ................................................. 48
11
Scope of Supply ................................... 48
12
Warranty ................................................ 49
Imprint
Version V01 / 2018-03
Copyright:
Maschinenfabrik
OTTO BAIER GmbH
Heckenwiesen 26
71679 Asperg
Germany
It is prohibited to forward or reproduce this docu-
ment or to exploit and disclose its contents, unless
expressly permitted. Any infringements will result in
liability to pay compensation for damages. All rights
reserved in case of patent, utility model or design
registration.
This instruction manual has been prepared with the
greatest possible care. Nonetheless, OTTO BAIER
GmbH does not accept any liability whatsoever for
possible errors in this instruction manual and their
consequences. Equally, no liability whatsoever is
accepted for direct or consequential damage or
losses resulting from improper use of the machine.
The national health and safety regulations and the
requirements of this instruction manual are to be
observed when using the machine.
All product names and brand names used are the
property of the holder and are not explicitly marked
as such.
Subject to change without notice.
Publicité
Table des Matières
