Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
•
Never use damaged insert tools. Before
each use, check insert tools for splinters
and cracks. If the power tool or insert tool
is dropped or falls, check whether it is dam-
aged, or use an undamaged insert tool. If
you have checked and inserted the insert
tool, keep yourself and other people nearby
outside the plane of the rotating insert tool
and let the power tool run at maximum speed
for one minute.
Most damaged insert tools break during this test
period.
•
Do not expose power tools to extreme heat
or cold.
Mechanical and electrical damage can occur
during extreme heat and/or cold.
•
Allow the insert tools, tool holders and oth-
er parts cool in the immediate vicinity of the
work area after use.
The equipment can be very hot after use. Do not
touch or grip the parts. Risk of injury.
•
Additional signs or other, non BAIER-
specific parts may not be screwed or riveted
onto the motor, handle, gearbox or protec-
tive housing.
This could damage the power tool and cause
malfunctions to occur.
•
Avoid unnecessary noise emissions.
•
Note and follow the safety and work instruc-
tions for the accessories used.
2.6.6 Hazards when using and
handling the drill stand
•
Before mounting the drill or drive unit, set
up the drill stand correctly in accordance
with these instructions.
Correct assembly is important to ensure proper,
faultless functioning of the stand.
•
Fasten the drill stand securely on a firm, flat
surface using the specified and undamaged
installation materials.
If the drill stand can slip or wobble, the drill or
drive unit cannot be guided uniformly and safely.
| 36 |
•
Disconnect the plug of the drill or drive unit
from the socket before mounting the drill or
drive unit on the drill stand, make any unit
settings or change accessory parts.
Unintentional starting of drills or drive units
causes accidents.
•
Fix the drill or drive unit securely onto the
drill stand as specified before starting work.
Slipping of the drill or drive unit on the drill stand
can cause loss of control and injuries.
•
Remove all setting tools, spanners and in-
stallation materials not required before
switching on the drill or drive unit.
Setting tools, spanners and installation materi-
als located in/on a rotating part of the unit can
result in injuries.
•
Do not overload the drill stand and do not
use it as a ladder or scaffolding.
Overloading or standing on the drill stand can
cause the centre of gravity of the drill stand to
move upwards and the drill stand overturns.
•
Do not use any accessories that have not
been especially provided and recommended
for this drill stand by the manufacturer.
Just because you can attach accessories to your
drill stand is not a guarantee of safe use.
•
Additional signs or other, non BAIER-specif-
ic parts must not be screwed or riveted onto
the drill stand.
This could damage the drill stand and cause
malfunctions to occur.
•
Note and follow all safety and work instruc-
tions for the accessories used.
•
Never place the feed crank handle on the
hexagon of the tapered shaft to tighten it.
Excessive torques could damage it.
Publicité
Table des Matières
