Collegamento Idraulico; Hydraulic Connections - Arbonia DXF Serie Manuel D'installation Et D'entretien

Table des Matières

Publicité

Depressione / Negative pressure / Unterdruck
Негативное давление / Depresión / Onderdruk
Ht = Pressione Totale (mm)
Ht = Total Pressure (mm)
Ht = Pression Totale (mm)
Ht = GesamtDruck (mm)
Ht = Общее давление (мм)
Ht = Totaaldruk (mm)
COLLEGAMENTO
IDRAULICO
Nei circuiti aperti (ad esempio
quando si utilizza acqua di pozzo),
l'acqua utilizzata deve essere ripu-
lita dai materiali in sospensione
per mezzo di un filtro che deve
trovarsi in ingresso (altrimenti c'è il
rischio di erosione da particelle in
sospensione). È inoltre necessario
assicurarsi che l'unità sia protetta
da polvere e altre sostanze che
provocano una reazione acida o
alcalina quando combinate con
l'acqua (corrosione dell'alluminio).
PRESSIONE MASSIMA
DI ESERCIZIO BATTERIA:
1600 kPa.
USARE SEMPRE
CHIAVE E CONTROCHIAVE
PER L' A LLACCIAMENTO
DELLA BATTERIA
ALLE TUBAZIONI.
PREVEDERE SEMPRE
UNA VALVOLA
DI INTERCETTAZIONE
DEL FLUSSO IDRAULICO.
Nel caso di macchina con baci-
nella raccogli condensa, effet-
tuare
la
sifonatura
secondo
schema previsto, (vedi targhetta
sull'apparecchio). Controllare che
non vi siano perdite dalle giun-
zioni. Per evitare perdite, arroto-
lare canapa sui filetti dei manicotti
di giunzione e serrare a fondo.
13
HYDRAULIC
CONNECTIONS
On open system (e.g. when using
well water), the water used should
be cleaned from suspended matter
by means of a filter which should
be located in the inlet. Otherwise
there is a risk of erosion due to
suspended matter.
You must also ensure that the unit
is protected from dust and other
substances that cause an acid
or alkali reaction when combined
with water (aluminum corrosion).
COIL MAXIMUM WORKING
PRESSURE: 1600 kPa.
ALWAYS USE
TWO SPANNERS
TO CONNECT
THE HEAT EXCHANGER
TO THE PIPES.
ALWAYS
FIT A GATE VALVE
IN THE WATER CIRCUIT.
If the appliance is equipped with
a condensate collection tray,
please always mount a siphon
according to the label on the
unit. Please make sure that no
leakage occurred. To avoid leak-
age please insulate the threated
ends of the tubes with hamp and
tighten them with care.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ecm serie

Table des Matières