Collegamento Idraulico - Arbonia Sabiana Ocean 1 Manuel D'installation, D'emploi Et D'entretien

Centrales de traitement d'air modulaires de faibles encombrements
Table des Matières

Publicité

COLLEGAMENTO
IDRAULICO
Parametri acqua
Valori massimi ammissibili
per l'acqua utilizzata all'interno
di un circuito chiuso di raffred-
damento o riscaldamento.
Nei circuiti aperti (ad esempio
quando si utilizza acqua di
pozzo), l'acqua utilizzata deve
essere ripulita dai materiali
in sospensione per mezzo di
un filtro che deve trovarsi in
ingresso (altrimenti c'è il rischio
di erosione da particelle in
sospensione). È inoltre
necessario assicurarsi che
l'unità sia protetta da polvere
e altre sostanze che provocano
una reazione acida o alcalina
quando combinate con l'acqua
(corrosione dell'alluminio).
ATTENZIONE:
PRESSIONE MASSIMA
DI ESERCIZIO: 10 bar
USARE SEMPRE
CHIAVE E CONTROCHIAVE
PER L'ALLACCIAMENTO
DELLA BATTERIA
ALLE TUBAZIONI
PREVEDERE
SEMPRE UNA VALVOLA
DI INTERCETTAZIONE
DEL FLUSSO IDRAULICO
Nel caso di macchina con
bacinella raccogli condensa,
effettuare la sifonatura secondo
schema previsto, (vedi
targhetta sull'apparecchio).
Controllare che non vi siano
perdite dalle giunzioni.
Per evitare perdite, arrotolare
canapa sui filetti dei manicotti
di giunzione e serrare a fondo.
17
WATER
CONNECTION
Water parameter
Limit values for the water
used in closed heating and
cooling circuits.
On open system (e.g. when
using well water), the water
used should be cleaned from
suspended matter by means
of a filter which should be
located in the inlet. Otherwise
there is a risk of erosion due
to suspended matter.
You must also ensure that the
unit is protected from dust and
other substances that cause
an acid or alkali reaction when
combined with water (alumi-
num corrosion).
ATTENTION:
MAXIMUM OPERATION
PRESSURE: 10 bar
FOR THE CONNECTION
OF THE BATTERY
WITH THE TUBES
PLEASE ALWAYS USE
A WRENCH AND A GIB
PLEASE
ALWAYS MOUNT
AN EXCLUSION VALVE
FOR THE WATER FLOW
If the appliance is equipped
with a condensate collection
tray, please always mount a
siphon according to the label
on the unit.
Please make sure that no
leakage occurred.
To avoid leakage please
insulate the threated ends
of the tubes with hamp and
tighten them with care.

Publicité

Table des Matières
loading

Table des Matières