Filling Oil Tank - Remington LNT-2 Manuel D'utilisation Et D'entretien

ASSEMBLY
Continued
Front Hand
Guard
Tapping
Screw
Guide
Bar
Bolts
Mounting
Stand-Outs
Figure 3 - Assembling Guide Bar, Chain, and Hand Guard
Adjusting
Block
Figure 4 - Part Locations For Assembling Guide Bar
100583
Cutting
Towards
Edge
Guide
Bar Nose
Cutting
Edge
Drive
Sprocket
Guide Bar
Nuts
Adjusting
Hole
Adjusting
Plate
Adjusting
Screw
Sprocket
Support
OWNER'S MANUAL
Saw
Chain
Guide
Bar
7

FILLING OIL TANK

1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil.
For temperatures below -1°C, use
Note:
SAE #10 oil. For temperatures above
24°C, use SAE #40 oil.
3. Replace oil cap at once. Tighten oil cap
firmly for good seal. This will avoid oil
seepage from tank.
4. Wipe off excess oil.
It is normal for oil to seep when saw is
Note:
not in use. Empty oil tank , tighten oil cap,
and store upside down after each use to
prevent seepage.